Радиоисполнитель 1-канальный, FA10UP – Jung

Описание

Radio Management

Radio actuator, 1-channel, flush-mounted
Intended use

• Radio-controlled switching of incandescent lamps, fluorescent lamps, HV halogen lamps and TRONIC or inductive transformers with halogen lamps
• Operation with suitable radio transmitters
• Suitable for mixed operation up to the specified output
• Installation in appliance box according to DIN 49073

Product characteristics of the switch actuator

• Light scene operation possible
• 2-point light control in combination with a radio presence detector possible
• Shut-off delay of approx. 1 minute in connection with radio motion detectors.

Product characteristics of the push-button actuator

• The push-button actuator closes its relay contact as long as it receives taught radio telegrams for switch-on, e.g. from a channel button of a hand-held transmitter or wall transmitter. If the corresponding channel button is released within the maximum transmission time, the push-button actuator opens the relay contact again.
• If the channel button is pressed for longer than the maximum transmission length of the transmitter, or if the transmission is faulty, then the relay contact is opened after approx. 16 seconds.
• If the taught channel button is pressed briefly, or a radio motion detector telegram is received, the relay contact closes for approx. 0.3 seconds.

Important: Energy saving lamps cause high inrush currents which may cause the switch contact to get stuck. Then a reduction of capacity is required! Please check suitability of lamps before installation.
The make contact has basic insulation internally and is separated from the phase.
The following loads can be switched: Functional extra-low voltage (FELV) or one phase L (230 V ~) against the neutral conductor N.
Technical data
Rated voltage: AC 230 V ~, 50/60 Hz
Switch contact: relay, μ-contact, 8 A
Circuit breaker: 10 A
Switching capacity
Incandescent lamps: 1000 W
HV halogen lamps: 1000 W
LV halogen lamps
– inductive transformer: 750 VA, with min. 85 % nominal load
– TRONIC transformer: 750 W
Fluorescent lamps
– non-compensated: 500 VA
– parallel compensated (47 μF): 400 VA
– lead-lag circuit: 1000 VA
Temperature range: −20 ... +55 °C
Dimensions: Ø x H = 52 x 23 mm, centre hole Ø = 7.5 mm
Approvals: VDE

Version: Switch

Manufacturer: JUNG
Ref.-no.: FA 10 UP